The Sanicubic 1 is a 1 HP heavy duty simplex grinder system used to pump away wastewater from several bathrooms and fixtures from an entire building structure.
This system is able to discharge the waste up to 36 feet vertical and/or 328 feet horizontal.
It incorporates a grinder system which is ideal for uncontrolled environments in both residential and commercial applications (ie. rental unit, offices, warehouses, etc).
The Sanicubic 1 is designed to handle sanitary products that may have been flushed down the toilet; such may consist of condoms, sanitary napkins, q-tips, dental floss, etc.
Discharges the waste through a 1-1/2 in. rigid pipe. A built-in non-return valve is included on the internal discharge pipe.
Has been designed with a 1-1/2 in. vent connection on the top of the enclosure. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.
The Sanicubic 1 is IP68 rated for possible submergence which eliminates any potential water damage to internal components. It comes equipped with an external control panel as well as a visual and audible alarm system (15 ft long wire).
The pump discharges wastewater from several toilets, sinks, bath/showers, urinals and even washing machines. The wastewater from other sanitary fixtures is drained into the Sanicubic 1 via four 1-1/2 in. or 4 in. inlets on either side of the housing and on top of the enclosure. Note that when draining wastewater into the pump through either of the side inlets, an external check valve (not supplied) has to be installed. Also, note that there should be a minimum 10 in. height difference between the base of the Sanicubic 1 to the bottom of the shower/bathtub drain or to the base of the toilet.
System can be installed above the floor, inside a pit or even retrofitted into an existing sewage ejector basin (at least 24 in. diameter)
Pump Type: Grinder
Electrical: 120v - 60Hz / 4.5 amps (max)
Motor: 1 HP oil-filled thermally protected motor
Capacitor Rating: 60 microfarad
Operating Temperature: 158 degrees F
Power Cord Length: 80 in.
Noise level (measured at 3 ft): less than 68 dBa (Lp)
Discharge Pipe: 1-1/2 in. diameter
Discharge Rate at 36 ft: 26 gpm
Discharge Rate at 3 ft: 50 gpm
Shut-Off Head: 45 ft
Normal Running Time: depends on number of fixtures
Capacity: 8.5 gallons
Inlets: 1-1/2 in. or 4 in. (side) 1-1/2 in. or 4 in. (top)
Method of Activation: Pressure switch / circuit board
Shower/bathtub Base Height: 10 in. minimum
Connections: Toilet, sink, shower/bathtub, washing machines (direct connection), etc.
Certified by CSA (IPC, NSPC), IAPMO (UPC)
Dimensions: 11-3/4 in. x 18-1/8 in. x 16-3/4 in.
Weight: 50 lbs