The Sanicubic 2 VX is a 1.5 HP heavy duty simplex Vortex system used to pump away waste water from several bathrooms and fixtures from an entire building structure.
This system is able to discharge the waste up to 36 feet vertical and/or 328 feet horizontal using 2 in. pipe or up to 20 feet vertical and/or 1640 feet horizontal using a 4 in. pipe.
This lift station is ideal for uncontrolled environments in both residential and commercial applications (ie. rental unit, offices, warehouses, etc).
The Sanicubic 2 VX incorporates a vortex impeller capable of handling up to 2 in. solids.
Discharges the waste through either a 2 in. or 4 in. rigid pipe. A couple of non-return valves are included on the internal discharge pipe connection of this system.
Has been designed with a 2-1/2 in. vent connection on the top of the enclosure. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.
The Sanicubic 2 VX is IP68 rated for possible submergence which eliminates any potential water damage to internal components. It comes equipped with an external control panel as well as a visual and audible alarm system (15 ft long wire).
The pump discharges wastewater from several toilets, sinks, bath/showers, urinals and even washing machines. The wastewater from other sanitary fixtures is drained into the Sanicubic 2VX via five 1-1/2 in. or 4 in. inlets on either side of the housing and on top of the enclosure. Note that when draining waste water into the pump through either of the side inlets, an external check valve (not supplied) has to be installed. Also, note that there should be a minimum 12 in. height difference between the base of the Sanicubic 2 to the bottom of the shower/bathtub drain or to the base of the toilet.
Smart-pump technology allows both pumps to work simultaneously if the incoming rate is higher than the discharge rate of the single pump. The discharge rate increases until the condition is alleviated.
Pump Type: Vortex
Electrical: 220 240v - 60Hz / 12 amps (max)
Motor: 2 x 1.5 HP oil-filled thermally protected motor
Capacitor Rating: 2 x 30 microfarad
Operating Temperature: 158 degrees F
Power Cord Length: 98 in.
Noise level (measured at 3 ft): less than 70 dBa (Lp)
Discharge Pipe: 2 in. or 4 in. diameter
Discharge Rate at 36 ft (2 in.): 40 gpm (both motors in operation) / Discharge Rate at 20 ft (4 in.): 110 gpm (both motors in operation)
Discharge Rate at 3 ft: 2 in. - 145 gpm (both motors in operation) / 4 in. - 250 gpm (both motors in operation)
Shut-Off Head: 43 ft
Normal Running Time: depends on number of fixtures

Inlets: 1-1/2 in. or 4 in. (side) 1-1/2 in. or 4 in. (top)
Method of Activation: Pressure switch / circuit board

Connections: Toilets, tubs and showers, sinks, washing machines, dishwashers, etc
Certified by CSA (IPC, NSPC), IAPMO (UPC)
Dimensions: 29-5/8 in. x 36 in. x 28 in.
Weight: 196 lbs